Boost controller installation manual

Installation: 1. Firstly, disconnect the intake hose which goes from the turbo to the airbox – this will make it easier to see all the parts you need. 2. Undo the two bolts in the side of the airbox (passenger side), which allows the airbox to be lifted clear of the car. 3. From Running Mode, use the “MENU” button to navigate to the Display setting (display scrolls “dISP”) Use the “UP/DOWN” buttons to select from “KPA” (default), “BAR” or “PSI”. Tap “MENU” to save and move on to the next menu item, or hold “MENU” to save and exit to Running Mode. display setting - units of pressure. Install the boost control solenoid using new vacuum lines. Mount the boost solenoid away from any direct heat sources and route all vacuum lines away from heat or moving parts. If the factory setup includes a restrictive mechanical control or an electric solenoid, they will need to be bypassed for the boost controller to work as intended.

Lines can be cut to any length that will allow for a suitable installation. Read through the instructions to find an application for your particular turbo setup. Section 1, The Basics: Our boost controller functions by interrupting the pressure line running to the wastegate actuator. The boost controller creates a differential in that line. 1. Attach supplied mounting bracket to manual boost controller using a 3mm hex wrench. 2. Find a proper location in the engine bay to mount the manual boost controller. You can either use the included bolt and nut (for through hole mounting), reuse a factory bolt, or use a zip tie to attach the boost controller. Identify the input nipple with the restrictor at the end on the DSBC tee piece. Loosen the input nipple and remove the ball and. spring. •. •. •. Check that the internal air passages are clear and free from debris. Re-install the boost controller by following the instructions for your setup.

HKS EVC III Boost Controller Installation Manual - Free download as PDF File .pdf) or read online for free. HKS EVC III Boost Controller Installation. 10 ឧសភា capping the boost control solenoid and the top port on the actuator-then basically install the MBC between the bottom actuator port and the. How to Install a Boost Controller (standard turbo, non-VNT) · Locate a source of turbo boost pressure for the input side of the MBC (manual boost controller).